Late 80's 200 Johnson tilt/trim problem

Mako68

Recruit
Thread starter
Joined
Apr 9, 2016
Messages
2
I have a 86 Mako with a 200 Johnson outboard. Motor trims fine and holds forever in the yard or on water, but will not trim while motor is in gear running. I can stop and trim motor but as soon as I give it throttle it pushes motor back into transom. Any ideas? Fluid is full and bled and haven't touched manual let down screw. Everything else works fine
 

wrench 3

Commander
Joined
Aug 12, 2012
Messages
2,108
Check to make sure that the manual release valve is tight. If that's OK then the hydraulic unit will have to be rebuilt. You have an "O" ring or a valve leaking inside the unit.
 
Top