bweisman12
Recruit
Thread starter- Joined
- Aug 29, 2016
- Messages
- 2
Hi,
So I just finishing tuning up (replacing everything under the flywheel) my Johnson JW-10. I put the flywheel cover back on but I'm not sure I'm doing it correctly. I slide the lever to the Start line and pulling the cord (really difficult) actually moves the lever back to the stop line and I can't pull it any farther. So clearly something is not properly placed.
This was obviously not the case before I removed the flywheel cover. Am I not lining it up correctly? I assume the groove at the base of the driveshaft is supposed to line up with the groove in the center hole in the flywheel cover? Confused!
Moving the throttle lever actually turns the prop!
Thanks for the help.
So I just finishing tuning up (replacing everything under the flywheel) my Johnson JW-10. I put the flywheel cover back on but I'm not sure I'm doing it correctly. I slide the lever to the Start line and pulling the cord (really difficult) actually moves the lever back to the stop line and I can't pull it any farther. So clearly something is not properly placed.
This was obviously not the case before I removed the flywheel cover. Am I not lining it up correctly? I assume the groove at the base of the driveshaft is supposed to line up with the groove in the center hole in the flywheel cover? Confused!
Moving the throttle lever actually turns the prop!
Thanks for the help.
Last edited: