JW-10 - Putting Flywheel back on incorrectly?

bweisman12

Recruit
Thread starter
Joined
Aug 29, 2016
Messages
2
Hi,
So I just finishing tuning up (replacing everything under the flywheel) my Johnson JW-10. I put the flywheel cover back on but I'm not sure I'm doing it correctly. I slide the lever to the Start line and pulling the cord (really difficult) actually moves the lever back to the stop line and I can't pull it any farther. So clearly something is not properly placed.

This was obviously not the case before I removed the flywheel cover. Am I not lining it up correctly? I assume the groove at the base of the driveshaft is supposed to line up with the groove in the center hole in the flywheel cover? Confused!

Moving the throttle lever actually turns the prop!

Thanks for the help.
 
Last edited:

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
Coils are most likely hitting the flywheel. They must be lined up flush with the mounting bosses on the armature plate. If they stick out too far, the result is the problem you're experiencing.
 

HighTrim

Supreme Mariner
Joined
Jun 21, 2007
Messages
10,486
Yeah, what he said ^^^^^, or flywheel has been split/widened. Rare, but seen it from over torque. More likely your coils are not set correctly.
 
Top