Johnson J50TLEOD...need some advice - ignition timing, etc.

C-Daddy 10

Recruit
Thread starter
Joined
Jun 7, 2018
Messages
5
Looking for some help here. Trying to sort out an engine that was running fine last year until late summer. Symptoms: boat hard starts, takes almost full throttle to fire. It runs horribly rich after that, and will start to die at anything under 2500 rpms. Someone tried to remedy the issue before me (it's my grandpa's boat). I've tried resetting the fuel screw's on the carbs anywhere from 1.5 to 4 turns out. No noticeable change in running. I've changed plugs, have great spark and new fuel. The person who looked at it before me put a new fuel pump on it. It looks like he also tried to adjust the timing.

I have no idea what the correct timing for this engine is and am having trouble finding it online. I have pulled and inspected carbs. They look new. I have pulled both reed valve assembly's. Both look OK, although I can see a little light coming through 1 of the 4 reeds in one assembly, and the same on the other. It's hardly noticeable. I did notice that when I pulled the air box off, there was gas in the box on the intake side of the carbs. Before I just replace the reeds, can someone tell me the correct timing on this engine so I can double check that? Also, if anyone has any other great ideas, I'm listening.

Thanks in advance for an help. The engine is a Johnson 50 outboard. I believe a 95 or 96.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The slight gap on the reeds is nothing to worry about.------Post the results of a compression test first.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
In what position is the red lever on the electric primer valve.----Are you pushing the key in while cranking it over ?----Does spark jump a gap of 3/8" on both leads , yes or no ?
 

C-Daddy 10

Recruit
Thread starter
Joined
Jun 7, 2018
Messages
5
I'm not totally sure what the electric primer valve is, but believe it is the schrader valve that either locks into what I'll call the 11 or 12 o'clock position and then rotates freely to the 3 or 4 o'clock position then locks again. I don't know what the normal position for this valve is for starting and / or running, but have moved it fully across the range while troubleshooting the issues I'm having. Also, spark does jump a 3/8" gap on both leads. I tested that last night....I've also tried key in while cranking. Doesn't seem to have much of an effect. The only way I can get it to start is to go full throttle and crank with key not pushed in. It fires, runs terrible up to 5000 rpms, then when back down throttle it dies around 2500 rpms. Again, horribly rich all the while.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The red ( manual ) lever should be in line with the primer valve body.
 

C-Daddy 10

Recruit
Thread starter
Joined
Jun 7, 2018
Messages
5
Copy that...when would you ever want to move this valve to any other position? Just curious.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
When you have a dead battery.-----You move the lever to open the valve.---Then operate the bulb on the hose.----Move lever back to the run position.-----Wrap rope around the flywheel to start the motor.----Yes that motor will run with a dead battery !
 
Top