Johnson 9.5 Cover Seal Advice

Jaggiebeard

Recruit
Thread starter
Joined
Aug 19, 2017
Messages
2
Hello all,

This is my first posting on this forum!

I've been reviewing a lot of the posts on here in the last month as I've been getting my old Johnson 9.5 running again. ( I would have never found the small jet in the fuel bowl without reading about it on here!)

I've finally gotten in running well after completely rebuilding the fuel and ignition systems. Now I'm moving into the 'make it pretty' part of the build.

Surprisingly the only thing on this motor that's given me issue so far is the seal that goes around the base on the fiberglass cover, mine's badly cracked. What can I do to replace this piece?

All comments and ideas welcome!
 

orbanp

Petty Officer 1st Class
Joined
Jun 26, 2011
Messages
324
Welcome to iBoats!

You did not say what year was your motor!

In any event, this place sells replacement rubber seals.
Just navigate to the parts page, and then to the cowl gaskets page.
There are probably other sources/sellers as well.

Peter
 

Jaggiebeard

Recruit
Thread starter
Joined
Aug 19, 2017
Messages
2
Peter,

It's a 1970 model. It was such a basket case when I started working on it that I'm surprised I've got to this point with it.

No joke it had been abandoned in a guy's shed and been in two floods. As near as I can figure it sat completely underwater for two weeks and then after that must have had water in the cylinders for two years.

After a lot of squirting every kind of solvent imaginable in the cylinders it finally got unstuck. I was still worried about the rings being stuck though, but I ran a compression test on it and both cylinders held 65psi.

I'm excited now to rebuild the lower unit and then get the old girl back in the water!
 

orbanp

Petty Officer 1st Class
Joined
Jun 26, 2011
Messages
324
Sounds like a fun project!
You have probably seen "LeeRoys' Rambling" web pages on these motors, if not check it out by all means!
A treasure trove of information!

Good luck, Peter
 

Bonaventure

Petty Officer 2nd Class
Joined
Jul 3, 2016
Messages
167
That compression reading is on the low side, I would think about a set of rings the next time you feel like doing something mechanical.
 

hardwater fisherman

Lieutenant Commander
Joined
Mar 19, 2010
Messages
1,725
According to leeroys ramblings compression of 65 to 75 psi is normal for the 9.5 hp. I own 2 of them. And they are both under 70psi.
 
Top