Jaggiebeard
Recruit
Thread starter- Joined
- Aug 19, 2017
- Messages
- 2
Hello all,
This is my first posting on this forum!
I've been reviewing a lot of the posts on here in the last month as I've been getting my old Johnson 9.5 running again. ( I would have never found the small jet in the fuel bowl without reading about it on here!)
I've finally gotten in running well after completely rebuilding the fuel and ignition systems. Now I'm moving into the 'make it pretty' part of the build.
Surprisingly the only thing on this motor that's given me issue so far is the seal that goes around the base on the fiberglass cover, mine's badly cracked. What can I do to replace this piece?
All comments and ideas welcome!
This is my first posting on this forum!
I've been reviewing a lot of the posts on here in the last month as I've been getting my old Johnson 9.5 running again. ( I would have never found the small jet in the fuel bowl without reading about it on here!)
I've finally gotten in running well after completely rebuilding the fuel and ignition systems. Now I'm moving into the 'make it pretty' part of the build.
Surprisingly the only thing on this motor that's given me issue so far is the seal that goes around the base on the fiberglass cover, mine's badly cracked. What can I do to replace this piece?
All comments and ideas welcome!