OK, so I tested compression and it is good at very close to 120 for all 4 cylinders. It runs fine with a extension wire attached to the throttle butterfly valve rod, but seems to die if not kept at fairly high rpm. The spark must be good for it to run so good at medium and high rpm. When we try to restart it, it is flooded and only by drying the spark plugs will it start again. It blows a lot of smoke, but yet, the ceramic on the spark plugs is totally white, no brown or black. Sometimes it seems the fuel tank bulb has to be squeezed a lot to get it to start, other times not. I thought it might be the fuel pump, but, again it runs, but maybe that is why it stops? I so far think I might need to clean the carb again (soak it this time) to get those idle circuits cleaned out. The first time I cleaned the carb, it idled for a short period of time. Maybe some junk got rearranged in there and plugged it up again? The motor is in good condition, probably with only a few hundred hours. Not dirty with oil and rust etc. I have purchased a CDI from E-bay (new) and when it gets here after I clean the carb, install it. What do you guys think?