Johnson 200 cyl overheat problem

nosbill

Recruit
Thread starter
Joined
May 28, 2016
Messages
2
I have a 1994 Johnson 200 and #6 (bottom right) is heating up. I replaced the water pump and head gaskets and cleaned out the passages and blew them out. When we start the engine on the muffs and when warming up the three left cyl's go to 135-140 and the lower right will go to 175 while the middle goes to 128-130 and the top one barely goes to 120. This takes about 5 min if that .The pressure is strong out the pee hole. Thank You for any help
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Compression test 1st.

It's possible you have a diverter that moved. Head would need to be removed to check.

One cylinder running hot could be a multitude of issues with some being as simple as pointing the laser temp in the wrong place. You could have a bunch of sediment that has settled in the cooling passages for example. It could be... See what I mean?

Someone will come along and have better ideas than me though.
 

nosbill

Recruit
Thread starter
Joined
May 28, 2016
Messages
2
I did clean the passages the best I could when I had the heads were off. I am sorry I didn't pull the diverters out to check them but didn't know their importance till I put the heads back on. Also right or wrong we checked the temps in the same place on all the cylinders. I visually looked for cracks too but didn't see any
 
Top