I bought a V4SL-12 and the old guy I bought it off had the leg off of it, said it was to much for him to tinker with anymore. I went ahead and bought all the parts to rebuild the leg and new impeller and seals etc. Was very careful with reinstall and lubing the water tubes and getting everything just right. It's pretty simple so can't see how i could have messed it up. Tried to start it today and gladly it fired right up just need to adjust the idle mixture a bit. I noticed it was not pushing water out the exhaust hole on the back of the motor and it heated up fairly quickly so im thinking it may not have water flowing through it?. My little 18 hp johnson has a thermostat and only starts to send out water after that opens. Gets hot but I know it's cooling. I shut it off when the head was to hot to to touch so surely did not damage anything by overheating. Am i being paranoid and all is well or should water be coming out the exhaust port right away? is there an easy way to test water is flowing by removing a hose on the power head?? Im used to the merc pee hole so not sure what to look for on this motor. thanks for the replies!