Johnson 10HP '96 running hot

mikeouel

Cadet
Thread starter
Joined
Jul 27, 2005
Messages
12
I would appreciate inputs. I have this old Johnson commercial version that was overheating due to a blown head gasket. I removed the head, clean passages, replace gaskets, put it together again. Also replaced thermostat and water pump. Yesterday I tested it at home with muffs and after about ten minutes it starting running hot, or at least what I think is hot. At the thermostat housing I was reading +-150F and at the head near spark plugs around 210F. I can tell the thermostat opens because the water out of the exhaust gets warmer and the temp stabilizes.It pees strong and there is water out of the exhaust. Isn't this too hot for an outboard? might it get cooler in the water at higher RPM?
Thanks!
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
^^agree with boobie. Can't test the cooling system on muffs.

Temps seem borderline, on the high side. Top of the head should show 120-140F at idle.

You might consider pulling the head and cleaning out (i.e., scraping out) the water passages. Sounds like there may be some salt corrosion. A fresh water flush in a barrel wouldn't hurt -- just idle, monitoring temp.
 

Lightwin 3

Petty Officer 1st Class
Joined
May 18, 2010
Messages
300
I agree on running it in a barrel. Little OB's don't like muffs.

When you put it in the barrel, make sure the water pump is submerged.
 

mikeouel

Cadet
Thread starter
Joined
Jul 27, 2005
Messages
12
Today I ran in in a barrel. After idling for about 5 minutes temp started to go up about 140F at the Tstat and 200F at the head around the spark plugs. Then I started to increase rpms and at a certain point the temp started to decrease very fast to 150f at the head and about 90f at the Tstat. I guess the springs at the tstat housing act like some kind of bypass at certain pressure. Are this small OB supposed to run hot at idle?
Thanks
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Nope. But you might have cleared a blockage. (Head temps are measured at the top of the head.)

I would try it again, letting it idle. See if it runs cooler.
 

mikeouel

Cadet
Thread starter
Joined
Jul 27, 2005
Messages
12
Ran it again yesterday in the barrel and temp at the head went up to 200F at idle and down to 145F at higher rpm. Removed the t-stat and tried again, 125f at idle and 145f at higher rpm. any ideas? T-stat and the rubber thing are new, and I can tell when it opens.
I think I'm going to be running it without the t-stat.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Don't know what to tell you -- temps w/o the t.stat are about right. The rubber thing you mention is probably the diaphragm, and I don't think that is installed on the 10, but could be wrong. You might test run it with the t.stat (no diaphragm) and see how it works.

[Edit. Still checking on this. What is your model number?]
 
Last edited:

thumbnut

Petty Officer 3rd Class
Joined
Sep 29, 2006
Messages
98
Sometime around 87 the thermo was moved to the top. The cooling jacket around the plugs was no longer and the thermo now "blows off" the seat or bypasses the thermo at higher rpms. 93 and up the thermo design was changed but still bypasses the thermo at speed.

Your temps mirror my motor with the bypass design.
 
Top