j150tlcsr 1980

hranec

Recruit
Thread starter
Joined
Jun 13, 2017
Messages
5
I bought a used non running johnson 150 v6, was told up front that it over heated and was towed in 3 years ago and has been sitting till I came along. Anyway I have replaced the water pump, drained and refilled the lower unit, rebuild the carbs, compression runs 107 to 117, I am now starting on the thermostats. BUT when I removed the thermostat covers I found what I'll call the (pressure valve) located just lower of the thermostats to be dry,crack and broken. So now I will start getting those parts together. Part # 86, 87, 88, 89, 95 and a few more. The QUESTION is part #89 WASHER,VALVE it sits inside of the cylinder head cover #24 and looks to be a tight fit maybe even pressed in. Is there any special way for part #89 to be removed and a new one installed???? I really do not want to break the head cover trying to get the old one out and the new one in. The book does not say anything except take it out and replace it.
THANKS for any and all help.
 

89Aluma

Petty Officer 3rd Class
Joined
Aug 23, 2016
Messages
89
Please post a few pictures of what your seeing and what the new part looks like
 

hranec

Recruit
Thread starter
Joined
Jun 13, 2017
Messages
5
Sorry but no pictures till the first of the month, boat is at the camper and I'm back home, It's just a metal cup type washer with a hole in the bottom part # 89 on the drawing and it sits on the out side (side facing you) on the cylinder head cover just lower than the thermostats. To me it looks like its pressed in I've not tried to pull it out yet was just thinking ahead
 
Top