interchangability of powerheads

highwayman56

Recruit
Thread starter
Joined
Dec 5, 2015
Messages
2
I have an early 65hp Johnson 3cylinder electric gearshift with a broken motor. I have a 60hp Evinrude 2 cylinder with a broken gearbox, cable gearshift. Is it possible to swap the Evinrude motor onto the Johnson, or the lower leg from the Johnson onto the Evinrude?? would hate to throw them away if I can make one from the two. thanks Graeme
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
A couple of critical things. The powerhead base gasket is different between a 72 65 hp engine and a later 60 hp version. Which probably means that even if the powerhead would bolt up, the exhaust/water passages are different between the two blocks. Likely they are not compatible. If you were to put the 65 hp gearcase onto the 60 hp, you'd encounter other problems. The 60 hp engine is setup with a mechanical shifting gearcase. The 72 is an electric shifting case-different animal. If you were somehow able to overcome that, then next up: The electric shift gearcase fit would have to be checked: Check the measurement of the two gearcases to make sure they are identical in length, driveshaft to top of the gearbox. Then also check the number of splines/diameter on the engine end of the driveshaft-they may not be the same. Perhaps someone that has tried this can offer their words of wisdom..
 

highwayman56

Recruit
Thread starter
Joined
Dec 5, 2015
Messages
2
thank you for the response, I will pull the two down and take some comparative measurements over the next week or so. It will be interesting to find out, Graeme
 
Top