I'm in the planning stage of installing a 200amp Battery isolator and doing a lot of research. I have a Perko switch right now. I'm running an 2008 350 Merc I/O. My intentions are to replace the switch so i don't have to go from one battery to another. I want a dedicate starting battery and a dedicated house battery. The starter will be a regular marine cranking battery and the house will be 2 kenityk HC2000 deep cycle batteries running in parallel. I'm running a very big setreo system so I plan on upgrading the Alternator from my 65 amp stock alternator to approx 200 amp Alt. My question
- Can I run the negative wires from battery #1 (starter) and battery #2 (house bank) in parallel and use the original ground wire to the grounding plate while using an Isolator.?
All wiring diagrams show sperate ground wires for each battery. I'm finding a hard time locating a secondary ground area given the confined engine area.
I look forward to all your help!!
- Can I run the negative wires from battery #1 (starter) and battery #2 (house bank) in parallel and use the original ground wire to the grounding plate while using an Isolator.?
All wiring diagrams show sperate ground wires for each battery. I'm finding a hard time locating a secondary ground area given the confined engine area.
I look forward to all your help!!