Re: Ignition switch prob??
You said, [---I have 12 volts on the same lead in]. What lead are you measuring? If you have an outboard, +12 volts reaches the ignition switch on the "B" (battery) terminal. No matter what you do with the wire or regardless of the switch position, that wire will always read +12 volts unless the fuse at the engine is blown (which apparently is not the case here). The only internal connection on the switch with it in the RUN position is that the "A" and "B" terminals are connected. Therefore, if you have a very weak battery, any accessories that are active in the RUN position may be pulling battery voltage down. Ensure you have a fully charged battery and that is capable of actually holding the charge. Have it load tested at any auto store.