So with outboard motors, you don't actually need to run anti-freeze through the motor. The way outboards are designed, the water all drains out f the motor when it is stored in an upright position. The reason you do that for I/O's is because the water stays in the engine block and exhaust manifolds, and if it freezes, it can crack the block or blow out a frost plug. If you leave the motor in a vertical position for a bit, all the water will be gone from the motor and you'll have no problems. I worked in a shop for many years in Northeastern New York--it gets cold up here--and we would only run anti-freeze in outboards if the owner insisted. It really doesn't do anything, as the anti-freeze runs out as soon as the motor is vertical again.
That being said, take out the spark plugs and spray some fogging oil in each cylinder, then turn the flywheel by hand and spray some more in each cylinder to coat the pistons and prevent any rusting. Then, when your ready to fix it up, get her running, change the gear lube, and start it up. It'll smoke a bit from the fogging oil. After you run the fogging oil out of the motor, you can swap in new spark plugs if you want. If it'll be stored outside, I also highly recommend placing some shrink wrap tape, or similar tape over the end of the prop, as you do not want any snow/water to seep into the prop seal area and freeze. that can ruin your prop seals and cause a lower unit leak. Cheap insurance.
Just my thoughts.