HD25 Magneto/Stator Plate issue

Porterhouse7070

Recruit
Thread starter
Joined
Dec 15, 2017
Messages
4
Hello all, a little back story. After my grandfather passed away i took this out of his basement. According to my father he could never get it running. So now, its my challenge. However, im not the most mechanically incline - this is my first attempt at working on a motor. So, here i am.

Ive been able get down to the stator plate. The magnet on top seems stuck, and i dont know how to get it off. Heres a couple pictures: http://imgur.com/a/mwSzMuU

The small brass or copper ring comes off but i cant figure out how to get the magnet and stator plate off. I loosened the bolt that pinches the plate, but nothing is budging.

Any help is appreciated! Thanks!
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
I would not take that off at all everything looks good on it. I would start with a spark test, compression test, Then check for fuel flow the screen in the tank can get plugged up. Get a manual and start with the basics.
 

Porterhouse7070

Recruit
Thread starter
Joined
Dec 15, 2017
Messages
4
I would not take that off at all everything looks good on it. I would start with a spark test, compression test, Then check for fuel flow the screen in the tank can get plugged up. Get a manual and start with the basics.

Spark test didnt go well. Ordered new plugs. Hopefully the magneto isnt the issue.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Clean the points and re gap them. Clean all the wire connections to shiny clean. Get a proper spark tester to test spark. F-R knows more about them than I do and he may have a different opinion.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
I find that 90% of the no spark problems on those motors are because of dirty points. And they are very difficult to clean in place. I remove them from the motor, take them apart, de-grease everything, and polish each contact separately, shiny bright. There are lots of little spacers & insulators, so pay attention. And do one set at a time so you have a sample how they go together.

Finally, after reassembling, set the gap to .020" at their widest opening. Bet you will have spark.
 

Porterhouse7070

Recruit
Thread starter
Joined
Dec 15, 2017
Messages
4
I find that 90% of the no spark problems on those motors are because of dirty points. And they are very difficult to clean in place. I remove them from the motor, take them apart, de-grease everything, and polish each contact separately, shiny bright. There are lots of little spacers & insulators, so pay attention. And do one set at a time so you have a sample how they go together.

Finally, after reassembling, set the gap to .020" at their widest opening. Bet you will have spark.

Awesome info! I will get it done of the course of this week/end and let you know how it goes. Thanks!
 

Porterhouse7070

Recruit
Thread starter
Joined
Dec 15, 2017
Messages
4
Spark test was promising. One wire and plug had sparks, the other did not. So it appears that i may have to give one of the mags a good inspection and as was mentioned above, a thorough cleaning.

thanks for the help again
 
Top