Gauge wiring question

klapwyk

Recruit
Thread starter
Joined
Aug 14, 2011
Messages
2
I just purchased a 1985 Seaswirl boat with a Johnson GT150 outboard motor. The tach flips clear over to max when the key is turned on and the speedometer doesn't work. I think I can fix the speedo, but the tach is where my question is. Someone has rewired this boat and they have the three wires coming from the ignition console coming into it. They are purple, black, and grey. They have taken the black wire and spliced it with another wire that runs directly back to the negative terminal on the battery. Will this create a problem with the tack?
 

NYBo

Admiral
Joined
Oct 23, 2008
Messages
7,107
Re: Gauge wiring question

Welcome to iboats!:cool:

Black should be connected to battery negative, so that part is good. It sounds like the other two wires may be reversed. Some boats/motors use purple for the tach signal, but others use grey, with purple being battery positive from the ignition switch. What are the letters next to the terminals on the back of the tach, and what color wires are connected to each?
 

klapwyk

Recruit
Thread starter
Joined
Aug 14, 2011
Messages
2
Re: Gauge wiring question

The wires go into a manufactured wiring harness that runs from the controller box where the ignition switch is to the back of the tach. So it doesn't have anything. There is a plastic case that has all of the wires going into it and that case plugs into the prongs on the back of the tack. The way the plug is designed it can only be plugged in one way. When I used a tester on the wires the purple seems to be the +12V feed. So unless they re-wired the plug it should be right. I will have to pull the plug off and look. What should the 12V plug into and what should the signal plug into Or I should say how is it labeled?
 
Top