I have a force 40 engine (0E062561) with a Tillotson WB110A carburetor. I was taking the carb apart to clean it and noticed something unusual. With the float bowl off and looking straight down the shaft of the main jet, there is a smaller brass tube going through the middle. The tube sticks out about 1/8 in past the screw-in brass jet. What i have doubts about is the brass tube is not centered in middle of the jet, it is slightly bent to one side. It doesn't look like the tube itself is bent, but rather its angle just isn't perfectly perpendicular to the carb so it ends up being angled slighly to one side and touching the edge of the jet as opposed to being positioned perfectly in the center (so that it doesn't touch the edge of the jet). I removed the brass jet and now the brass tub touches the edge of the injet shaft as opposed to being positioned straight down the center. Is this unusual or is it normal?
