Fleetwin Fuel Pump Removal

Tajercycle

Recruit
Thread starter
Joined
Apr 21, 2017
Messages
4
Hello every one ,so I'm a new be to this forum and to the wonderfull world of outboard motors, so I started building a vintage Hal Kelly designed 10 foot hydroplane,which at this point is 75% done, I picked up a 1954 evinrude 15 hp fastwin, which is in very good shape I just finished servicing ,in the mean time a friend of mine gave me a 1960 10 hp fleetwin, which is also in very nice shape which I want to also service, now my question is about removing the fuel pump to over haul, if I'm correct it looks like I have to remove the power head to remove it due to the screws which attach it being below the lower shroud, anyone have any idea, thanks
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
You must be kidding here.----No 1/4" socket set with screw driver bits in it ?
 

pckeen

Commander
Joined
Jun 20, 2012
Messages
2,067
Unless there is something unusual about that model, you can simply unscrew the fuel pump, can't you?
 

Tajercycle

Recruit
Thread starter
Joined
Apr 21, 2017
Messages
4
Let me rephrase the question did the factory mount the fuel pump on the top cylinder or bottom,if the fuel pump was mounted on the top cylinder I could have my 8 year old granddaughter remove it ,but it's mounted on the lower cylinder behind the shroud and theirs no access to the right lower mounting screw which is under the fuel line nipples
 

Tajercycle

Recruit
Thread starter
Joined
Apr 21, 2017
Messages
4
After looking at pictures on the internet the fuel pump should be mounted on the top cylinder ,mine is on the bottom, the engine is also painted a dark blue so it may have been replaced or over hauled at one time
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Might post a pic or two. The covers are probably interchangeable, so you could likely move the pump up depending on room under the hood. You might try a screwdriver bit and a small needle nosed vise grip to get at the mounting screw.
 

Tajercycle

Recruit
Thread starter
Joined
Apr 21, 2017
Messages
4
Thanks for the reply oldboat1 ,I should have no issues with the upper cowl clearance ,tomorrow I'll try removing the fuel line fittings from the pump and removing the nuts off the lower shroud for clearance ,I'm 100% sure the pump should be mounted on top cylinder, and to racerone supreme mariner thanks for the sarcasm buddy
 
Top