JoeCrow
Petty Officer 1st Class
- Joined
- Nov 1, 2007
- Messages
- 218
I got a 2002 Mercury 125 and am in the process of installing it
I bought a new controller Quicksilver 881170A20
The directions covered the cable installation and showed the plug for the tach but there are 4 "loose" wires on each end of the harness
The direction never even showed them let alone explained what they are for
Are they for overheat alarm?
Low oil alarm?
If so which is which and why didn't they show them in the book?
If not, where are the alarms supposed to go?
Any help would be appreciated, I got the thing on e-Bay and the seller was no help
Thanks
I bought a new controller Quicksilver 881170A20
The directions covered the cable installation and showed the plug for the tach but there are 4 "loose" wires on each end of the harness
The direction never even showed them let alone explained what they are for
Are they for overheat alarm?
Low oil alarm?
If so which is which and why didn't they show them in the book?
If not, where are the alarms supposed to go?
Any help would be appreciated, I got the thing on e-Bay and the seller was no help
Thanks