Evinrude yachtwin 3532a not running

Jhall706

Recruit
Thread starter
Joined
Jul 6, 2018
Messages
2
It's not getting fuel I clean the carburetor It looks good It will run if I spray gas into it. It don't seem like It's geting in enough air through the carburetor. What could be the problem
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
It can'r run without air, so if it runs when you squirt gas into it, it is getting air. Did you inspect the high speed jet in the carburetor? It is deep in the hole behind the hex drain plug. It must be absolutely CLEAN. But don't be jamming wires or drills & stuff through it. Too big is as bad as too little.

Also--are you sure the carb is filling? Could be a clogged fuel filter in the tank if it isn't filling.
 

Jhall706

Recruit
Thread starter
Joined
Jul 6, 2018
Messages
2
Yes the main jet is cleaned out it really wasn't clog Up And the Bowl is filling up with Fuel
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Yes the main jet is cleaned out it really wasn't clog Up And the Bowl is filling up with Fuel

The wording in that statement concerns me. That jet must be absolutely, positively CLEAN without a trace of any dirt, gum or varnish in it. Is it? If not, the symptom will as you describe.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
F_R is right that you shouldn’t be reaming the jets, but I’m a big believer in some careful soaking and poking. Disassemble the carb and soak in lacquer thinner or something that cuts through fuel varnish, then use a soft wire or piece of monofilament to run into and through every opening. Finish with carb spray, using the plastic nozzle to again hit the small holes. Take off the domed cover on the top before soaking and thoroughly clean out the idle passages underneath.

[Edit: BTW, you could have the broken point of a needle jammed into the orifice in the carb body -- might not be aware of that without taking the domed cap off and looking. It's a good idea to test fit the needle with the cap off so you can see that the point properly fits the opening -- that the opening wasn't damaged by a PO.]
 
Last edited:
Top