evinrude big twin

Rowan Blank

Recruit
Thread starter
Joined
Jul 10, 2018
Messages
1
Hi guy's i have picked up two old evinrude big twin 40302d 40hp motors, i have ordered one tune up kit from max rules and have started pulling one apart, both the motors are in pretty ruff shape but both have good even compression on both cylinders, i have pulled the cylinder head off one to have a look and to get the head skimmed a little as it was not perfectly straight. the problem is most of the bolts on these motors are very rusty and i am not relay wanting to put them back in.
my question is what can i use as replacement bolts for the head? i don't want to buy the original ones from (*****************) as they are nearly 10usd each and i would have to ship them all the way to nz.

My second question is dose anybody know what to torque the head bolts to on this model of evinrude?

Third question is what to torque the flywheel nut to?

Any help is much appreciated and look forward to your reply's.
 
Last edited:

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Head bolts 168-192 inch lbs
Flywheel nut 100-105 foot lbs
Take a bolt to your hardware store and see if they have anything to match. OMC was good at using non-standard lengths and/or thread length.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
"OMC was good at using non-standard lengths and/or thread length."

That is one good reason to use OEM bolts, especially for things like cylinder head bolts and crank case bolts
 
Top