Rowan Blank
Recruit
Thread starter- Joined
- Jul 10, 2018
- Messages
- 1
Hi guy's i have picked up two old evinrude big twin 40302d 40hp motors, i have ordered one tune up kit from max rules and have started pulling one apart, both the motors are in pretty ruff shape but both have good even compression on both cylinders, i have pulled the cylinder head off one to have a look and to get the head skimmed a little as it was not perfectly straight. the problem is most of the bolts on these motors are very rusty and i am not relay wanting to put them back in.
my question is what can i use as replacement bolts for the head? i don't want to buy the original ones from (*****************) as they are nearly 10usd each and i would have to ship them all the way to nz.
My second question is dose anybody know what to torque the head bolts to on this model of evinrude?
Third question is what to torque the flywheel nut to?
Any help is much appreciated and look forward to your reply's.
my question is what can i use as replacement bolts for the head? i don't want to buy the original ones from (*****************) as they are nearly 10usd each and i would have to ship them all the way to nz.
My second question is dose anybody know what to torque the head bolts to on this model of evinrude?
Third question is what to torque the flywheel nut to?
Any help is much appreciated and look forward to your reply's.
Last edited: