Been having issues with this motor 1977 evinrude 70(70773S). The latest issue is not wanting to idle when in the water. I rebuilt the carbs a couple weeks ago when I was having an issue with transitioning from idle that was worked around by tapping the choke. That problem is fixed. I started looking at ignition because the carbs were rebuilt and I had a problem with loosing a cylinder suddenly on one trip. The ignition has good strong spark and good ohm and DVA readings so my thought was reeds.
I pulled the air box to look for fuel spit at idle and found none but found something else. #3 (that's the bottom cylinder right?) is running very lean. I was spraying carb cleaner around looking for vacuum leaks when I didn't find any I shot a small squirt down the carb. On #1 and #2 it caused the motor to stumble but on #3 it changed the engine note but the motor seemed to speed up slightly. I then disconnected the choke linkage so I could close them independently and when I close #1 or #2 the motor stalls (#2 stalls quicker than #1). #3 just causes the motor to smoke a bit more and changes the exhaust note but the motor will not stall no matter how long I hold it. When I pull a plug wire on #3 the exhaust note changes so it is fueling but clearly not enough. This is a serious issue but I'm not sure what could be causing it. There is nothing to the carbs just some plugs that cover machined passages two jets and a float bowl. I cleaned them thoroughly and blew everything out with air. The needle and seat was changed as was the float. I inspected all passages to make sure they were clear before setting the new plugs and putting them back together. I set the float height per the instructions in the carb kit (sierra)
Any advise on determining if the carb is working after I take it apart again? I suppose the float could be stuck closed but I checked it by blowing through the fuel inlet before they were put back on and they all opened and closed as they should.
Any advise would be greatly appreciated.
I pulled the air box to look for fuel spit at idle and found none but found something else. #3 (that's the bottom cylinder right?) is running very lean. I was spraying carb cleaner around looking for vacuum leaks when I didn't find any I shot a small squirt down the carb. On #1 and #2 it caused the motor to stumble but on #3 it changed the engine note but the motor seemed to speed up slightly. I then disconnected the choke linkage so I could close them independently and when I close #1 or #2 the motor stalls (#2 stalls quicker than #1). #3 just causes the motor to smoke a bit more and changes the exhaust note but the motor will not stall no matter how long I hold it. When I pull a plug wire on #3 the exhaust note changes so it is fueling but clearly not enough. This is a serious issue but I'm not sure what could be causing it. There is nothing to the carbs just some plugs that cover machined passages two jets and a float bowl. I cleaned them thoroughly and blew everything out with air. The needle and seat was changed as was the float. I inspected all passages to make sure they were clear before setting the new plugs and putting them back together. I set the float height per the instructions in the carb kit (sierra)
Any advise on determining if the carb is working after I take it apart again? I suppose the float could be stuck closed but I checked it by blowing through the fuel inlet before they were put back on and they all opened and closed as they should.
Any advise would be greatly appreciated.