BT1280
Cadet
Thread starter- Joined
- Mar 28, 2018
- Messages
- 12
Hey Guys. First time. I have a 1994 Evinrude 48 spl. This has been a great motor in the two years I have had her. Last year I replaced the power pack, charge coil, plugs, cleaned, and rebuilt carbs, as well as disassembled and cleaned controls, etc. Motor was running great until a couple days ago. I have had it out in the bay as well as a couple lake trips with not even a hiccup. She always starts on the first key turn and never gives me one issue. Then when I was fishing the other day, I went to turn her on and go to a different spot and it would just crank and not start. Good battery, good starter speed, just wouldn’t start. Next day, started right up. No issues. Idles and runs perfect. Then the very next day it was doing the same thing of turning but not starting. Good fuel, primer solenoid tested and passed, good spark on both plugs and replaced plugs just in case. Tested the stop safety circuit, neutral, forward, and reverse circuit from the engine wiring harness back to the control and it all passed.
This is one has me baffled, because it has good fuel and spark when it is doing this. Then today I hit the key two times in a row and it started and ran fine all day. Turned it off multiple times to try to duplicate problem and it wouldn’t do it. Thoughts? If this was a timing issue, I don’t think it would run perfect the rest of the time, right?
Thanks
This is one has me baffled, because it has good fuel and spark when it is doing this. Then today I hit the key two times in a row and it started and ran fine all day. Turned it off multiple times to try to duplicate problem and it wouldn’t do it. Thoughts? If this was a timing issue, I don’t think it would run perfect the rest of the time, right?
Thanks