Evinrude 30hp flywheel

nsraspud2

Recruit
Thread starter
Joined
Apr 7, 2016
Messages
3
I have a 1994 30 hp Evinrude E30ELERM. The flywheel has a couple of bad teeth causing the starter to "hang up" every once in a while. I want to replace the flywheel but have run into the following issue. :

The Evinrude OEM # is 0584373 which was superseded by a 0585158 which was again superseded by a 0583001.

The flywheel I took off the motor is a 513863.......very confusing.

Can someone shed some light on this ?? What number should I look for ?? And even though a 0583001 does not look like the flywheel I removed will it work ???

Thanks for any help I can get . LOL
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
There are many flywheels that will work.-----------The same year after year.-----------Find a flywheel with a steel gear if yours is a one piece cast iron one.
 

nsraspud2

Recruit
Thread starter
Joined
Apr 7, 2016
Messages
3
Thank you very much. Does anyone know the part #'s of flywheels that have steel teeth ??
 

nsraspud2

Recruit
Thread starter
Joined
Apr 7, 2016
Messages
3
There are many flywheels that will work.-----------The same year after year.-----------Find a flywheel with a steel gear if yours is a one piece cast iron one.


Can you give me any part numbers to go by ? Also is the flywheel key location to the magnets critical ? I also see it is a 74 tooth flywheel . There are many 76teeth out there but that would seem too big ( Duameter) Thanks for helping me clear this up.
 
Top