Evinrude 25 HP E25RCCA stall during acceleration

travisj2001

Cadet
Thread starter
Joined
May 10, 2015
Messages
9
I recently acquired a 1988 Evinrude 25 HP outboard (E25RCCA). I have been messing with the thing for a few weeks and have it to a point to where it idles properly but when increasing RPM is will stall. I initially thought it was a dirty carb so I rebuilt that and still have the same issue. When on the water yesterday I discovered that if I place my hand over the carb to restrict the airflow when accelerating it runs like it should. I thought I must have a carb air filter air box that is missing but when looking for parts I discovered that this motor does not have one. I am thinking the throttle butterfly in the carb must be opening too much and that the throttle linkage is not correct. Full throttle results in the butterfly being completely parallel to the water. Can anyone help?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Could be that the low speed mixture is too lean and that DEFINITELY affect acceleration.----So open up the low speed mixture a 1/4 turn and see if that helps.-----The adjusting collar on that thin metal rod that goes to the back is often adjusted by folks.----It appears to be wrong when it is correctly adjusted.--At the idle position there usually should be a gap of about 3/16" or 5 mm.---If throttle opens too early the motor will stall.
 

travisj2001

Cadet
Thread starter
Joined
May 10, 2015
Messages
9
I will try the low speed adjustment and check the gap next time I hit the water.
 
Top