evinrude 1969 electric shift problem

augusto rivas

Cadet
Thread starter
Joined
Feb 24, 2015
Messages
9
Good morning, everyone. This is my first post on this site. My name is Augusto Rivas and I am from Mendoza, Argentina. A year ago we bought a 1969 Evinrude 85hp engine model with hydroelectric gearbox. The gear command (switch control) was broken so I searched for information on the web and on this page I found a solution to make it work with individual keys, and now the reverse and the neutral work but I have trouble with the forward gear. It sometimes assembles the clutch well but sometimes it doesn?t. It?s as if there was no assembly at all, exerting force on the axis of the propeller. The oil we are using is the atf DEXRON 2 since the co Premium blend of brp isn?t very easy to get here. I wanted to ask you if it can be a problem that the clutch is stuck and if disassembling the gearbox is the best solution. You can also tell me if I can do this job myself or it?s too complicated. Thank you very much for your time. Regards
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
With no voltage applied to the shift solenoids there is a spring that forces the clutchdog to slide into the forward gear.----If it is not engaging then likely there is debris in the shift piston bore.---If that is the case you will need to clean that bore.------Not impossible to do , but you will need a large pair of pliers to take out 2 big internal rings to get the gearcase apart.----Myself I find these gearboxes easy to work on.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
What racerone said....Disconnect the two wires leading down to the lower unit. It should then be in forward, since there is no power being applied to the shift solenoids. I guess you know it is always in forward if not running.
 
Top