Fellers, please help.
My eventide intruder spitfire series recently got to where the starter wouldn't work. It sounded like the flywheel was chewed up...and the starter wouldn't turn fast nyff. I pulled the Bendix and cleaned and oiled it. Then it wouldn't engage. I bypassed the wires and ran jumper cables directly to the starter....same. turned out Bendix was stripped. Changed starter and Bendix...it will start, np. However, took to lake and still get same horrible sound when starting but it starts. No hesitation to start. Engine has a ping sounds and i suspect it's nkt firing on all cylinders. Ran it slowly up lake then the whistle went off and it died. Then it wouldn't turn the engine over like a dead battery. I charged battery so that shouldn't be the problem. But it's seems like something is stealing all the juice. I did mess around with wiring rebooking up started prior to these problems so maybe I hooked something up wrong. Here's the kicker. I hooked up thr horn...it's universal polarity...as soon as I hoold it up the horn blew whether I had it on or not. I pulled the hot wire to shut it off...and accidentally touched the hot wire to something metal that cause it to ground...and it started blowing. How in the world can a horn blow when there's no juice supplied to it with the hot wire disconnected? Additionally...it seems that thr whole system reboots after accidentally touching a hot wire to something it shouldn't have been touching and fixes problems it's having. Iv checked all wires to make sure I don't have any hot wires hooked up to the negative side if fuse box and vise versus...but can't find anything...but...it's an older boat so not all wires are factory color. Can anyone help? I think it's a pre 95 model motor cause the Bendix isn't on top of stRtet...it's a seperate component....
My eventide intruder spitfire series recently got to where the starter wouldn't work. It sounded like the flywheel was chewed up...and the starter wouldn't turn fast nyff. I pulled the Bendix and cleaned and oiled it. Then it wouldn't engage. I bypassed the wires and ran jumper cables directly to the starter....same. turned out Bendix was stripped. Changed starter and Bendix...it will start, np. However, took to lake and still get same horrible sound when starting but it starts. No hesitation to start. Engine has a ping sounds and i suspect it's nkt firing on all cylinders. Ran it slowly up lake then the whistle went off and it died. Then it wouldn't turn the engine over like a dead battery. I charged battery so that shouldn't be the problem. But it's seems like something is stealing all the juice. I did mess around with wiring rebooking up started prior to these problems so maybe I hooked something up wrong. Here's the kicker. I hooked up thr horn...it's universal polarity...as soon as I hoold it up the horn blew whether I had it on or not. I pulled the hot wire to shut it off...and accidentally touched the hot wire to something metal that cause it to ground...and it started blowing. How in the world can a horn blow when there's no juice supplied to it with the hot wire disconnected? Additionally...it seems that thr whole system reboots after accidentally touching a hot wire to something it shouldn't have been touching and fixes problems it's having. Iv checked all wires to make sure I don't have any hot wires hooked up to the negative side if fuse box and vise versus...but can't find anything...but...it's an older boat so not all wires are factory color. Can anyone help? I think it's a pre 95 model motor cause the Bendix isn't on top of stRtet...it's a seperate component....