Eventide won't run..

Turbolung

Cadet
Thread starter
Joined
Aug 29, 2016
Messages
8
Fellers, please help.

My eventide intruder spitfire series recently got to where the starter wouldn't work. It sounded like the flywheel was chewed up...and the starter wouldn't turn fast nyff. I pulled the Bendix and cleaned and oiled it. Then it wouldn't engage. I bypassed the wires and ran jumper cables directly to the starter....same. turned out Bendix was stripped. Changed starter and Bendix...it will start, np. However, took to lake and still get same horrible sound when starting but it starts. No hesitation to start. Engine has a ping sounds and i suspect it's nkt firing on all cylinders. Ran it slowly up lake then the whistle went off and it died. Then it wouldn't turn the engine over like a dead battery. I charged battery so that shouldn't be the problem. But it's seems like something is stealing all the juice. I did mess around with wiring rebooking up started prior to these problems so maybe I hooked something up wrong. Here's the kicker. I hooked up thr horn...it's universal polarity...as soon as I hoold it up the horn blew whether I had it on or not. I pulled the hot wire to shut it off...and accidentally touched the hot wire to something metal that cause it to ground...and it started blowing. How in the world can a horn blow when there's no juice supplied to it with the hot wire disconnected? Additionally...it seems that thr whole system reboots after accidentally touching a hot wire to something it shouldn't have been touching and fixes problems it's having. Iv checked all wires to make sure I don't have any hot wires hooked up to the negative side if fuse box and vise versus...but can't find anything...but...it's an older boat so not all wires are factory color. Can anyone help? I think it's a pre 95 model motor cause the Bendix isn't on top of stRtet...it's a seperate component....
 

GA_Boater

Honorary Moderator Emeritus
Joined
May 24, 2011
Messages
49,038
Welcome aboard.

What in the world is an "eventide intruder spitfire"? I think auto correct chewed on your message. Evinrude Intruder Spitfire by any chance?

Moving this into the Johnson/Evinrude section.

You should be more careful with hot wires. You can fry a lot of expensive parts.
 

Turbolung

Cadet
Thread starter
Joined
Aug 29, 2016
Messages
8
I was told to cut a portion of the springs for the thermostat off to help keep the electronics cool...it was a reputable eventide mechanic...so I did..about an inch off...could that have caused this?
 

Turbolung

Cadet
Thread starter
Joined
Aug 29, 2016
Messages
8
Btw....boat tan perfect prior to all this...I havr no doubt battery is prolly bad...but as said...ran perfect prior to starter issues...I labeled evey wire when removing and reinstalling starter....but I am new to working on boats...I also disconnected the aerator control ad this is the only thing I originally messed with prior to all the issues...
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
If the alarm went off and it quit running then the starter struggled to turn it over. Those are all signs of an overheat.How old was the waterpump.
 

Turbolung

Cadet
Thread starter
Joined
Aug 29, 2016
Messages
8
Not sure but the motor was rebuilt not ling before being bought..I do get water shooting out the exit hole...not debating your answer...just shocked caude i thougjt it was a wire I hooked up wrong. The whole horn going off regardless of whether the switch was on or off...and going off when I disconnected the hot wire and touched it to the metal part of the steering cable thing where it connects to steering wheel led me to an electrical problem theory...how do you check the water pump? Btw...I'm.grateful foe your input...
 

Turbolung

Cadet
Thread starter
Joined
Aug 29, 2016
Messages
8
Cutting off part of thermostat springs

I was told to cit off some of the thermostat springs to help keep the electronics stay cooler. I did this after replacing the starter and Bendix as I was having starter issues. First time back on water and as soon as I come up off idle an alarm went off and motor died. Starter would not turn back over....which jsnt uncommon lately as iv had alkt of issues keeping the battery charged..or at least that's what I suspect since it seems to die quickly. I also messed around with some wiring to get my aerator timer hooked back up. Here's the kicker...in case it's related....I had a fuse that kept popping...not sure what it was hooked up to and removing it and not replacing didn't seem to affect anything....AND..after realizing I had the positivr and negative wires hooked up backwards...according to internet..I swapped em around. The cig lighter outlet worked fine that way..I also messed with hooking horn back up as I read if the wires aren't marked it doesn't matter which is used for positive and negative. ..something happened when I did that that caused cig lighter outlet to stop working...gauge lights too..then..suddenly they all worked again. When I hooked horn up it didn't matter which wire went where or what position switch was in..it blew. Freaky part..when I removed positivr wire to **** it off...I accidentally touched the positive wire..which haf no power on it..to the metal square tubular part of steering cables..and it blew...?, Wth? With no power fed to it and only grounded? Those cig lighter issues...seemed to go away when I touched a ground wire to the horn itself...anyway..also tried hooking fish finder up to a red hot wire coming up from back of boat from wire harness...but fish finder wouldn't stay on..so hooked it up to a diff hot wire and it stayed on np...I ran brand new neg wire from battery to secondary fuse panel...checked all ground wires and every single thing I could check..all grounds..you name it....and..as said...engine starts right up evry time..ran fine at house on ear muffs...put it lake and started up..siunds like it's dying when starting but starts..idled fine but had a ping sound and kind of makes me think not all cylinders are firing...idled out of no wake zone..throttled up amd engine died with alarm going off. I k ow thats it for you to digest....but could cutting down the thermostat springs cauded engine to die and alarm to go off? Additionally...thr engine dying started prior to starter isdurd as I was cruising along one day shortly after leaving boat dock and throttled up after leaving no wake ,one and engine died...wouldn't start again. Didn't have the starter issues then or the bad sound as if the flywheel was grinding or anything......please share your thoughts fellers....
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
You already have a thread discussing this, so this one will either be merged or closed.

But, those aren't thermostat springs, they open as the water pressure from the pump increases, nothing to do with temperature, this keeps the motor cool at higher RPMs. In the other thread you said a mechanic told you to do it, find another mechanic, this will do nothing to keep the eletronics cooler, and if you did it incorrectly it may have destroyed your motor.
 

GA_Boater

Honorary Moderator Emeritus
Joined
May 24, 2011
Messages
49,038
Turbolung - Please keep your questions in one thread. This is getting difficult to follow as it is and starting new threads only makes it harder.
 

Turbolung

Cadet
Thread starter
Joined
Aug 29, 2016
Messages
8
Sorry guys...s.I'm freaking out over this...scared it's gonna cost more to fix than I can comeupwith..I started to only ask out the springs but felt cmpelled to give all the details..which post should I delete? I'm new to this...
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
I am going to be the bearer of bad news. You need to find a GOOD mechanic and take your motor to him. You have way to much going on
 

Turbolung

Cadet
Thread starter
Joined
Aug 29, 2016
Messages
8
K..I think I'm posting in the correct place now..as to the alarm..that alarm went off a few years ago when I had a pin hole in he fuel primer ball suckling air..it wouldn't run then..replaced fuel line with said primer ball and fixed issue...hopefully it's not overheating. I haven't used this motor much at all in a year and mainly troll being my lake is very small and I prefer the end of lake I launch at...not sure how many details are needed to give a well informed analysis
 

GA_Boater

Honorary Moderator Emeritus
Joined
May 24, 2011
Messages
49,038
Don't delete any posts. I have put all posts in one thread.

You are trying to explain too many things at one time. You have cooling problem, electrical problems, starting problems and I don't what else.

It's time to slow down and take one thing at a time. First is the motor starting and running right now?
 

Turbolung

Cadet
Thread starter
Joined
Aug 29, 2016
Messages
8
I haven't had a chance to touch it since Saturday when this happened...I will put the muffs on it tomorrow eve and report back on it. I'm sure I will have to charge the battery first as it seems to drain super fast.
 

Faztbullet

Supreme Mariner
Joined
Mar 2, 2008
Messages
15,938
Take the repair bill to the mechanic that told you to cut the springs......
 

mjf55

Chief Petty Officer
Joined
Jun 17, 2014
Messages
462
I don't want to confuse the situation as you do need to focus on one issue at a time. When you charge the battery to answer GA's question as to the motor starting / running now, you should have the battery load tested to see if the rapid discharge of the battery is just a bad battery, or an indication of your electrical problem.
A place like Auto Zone or Advanced Auto can test it for you. I am not saying to buy a new one yet, just lets know if this one is bad.

Edit: What is the model of the motor as it is listed on the transom bracket?
 
Top