Just recently bought a 16ft basstracker with a 40HP Evinrude, the specs are; E40elccs, 88 model. I bought it from my cousin and have been around the boat a bunch, well taken care of and never given us any major trouble. It has ALWAYS clicked while putting the gear shift in fowards, it recently haa gotten very bad and "jumpy". When i attempt to launch in a no wake zone i have to go back and forth unti it essential grabs/slams into foward gear. Then it runs fine, it planes out and doesnt hiccup and i cant feel anything slipping in the motor or lower unit. Well yesterday it wouldn't go into gear at all, only reverse but i couldn't get it more than slightly above idle in reverse...So, when i got it home I spun the prop and it will spin both ways in fwds and neutral, but wont spin in reverse because now it wont shift into reverse at all! I have checked the cables but am unsure on whats proper procedure on getting in correct. Also if its worth anything, the lower unit oil was changed when we got got it, only been out 20 or so times since the change. This is my first boat so im a little lost but have my whole lifetime dealing with cars, engines and all things mechanical. Just looking for some pointers, Thanks.
Also, the engine still runs fine, it fires right up, idles fine and will rev, but just wont allow me to shift into gear.
Also, the engine still runs fine, it fires right up, idles fine and will rev, but just wont allow me to shift into gear.