Depth finder

[CWR782]

Anyone know how to remove this? I have tried flipping and sliding the center piece down to access the fasteners behind but it has not worked. It is an old model Hummingbird depth finder.

 

[Scott Danforth]

tap upward. the bracket is wedge shapped and the outer bracket snaps into the part screwed to the hull.

 

[roffey]

I have taken them off before and you unscrew the nut, pull the bolt out and it slides off, a little to easy. I'm thinking there is a lock washer on the inside or wrong side of the bracket and now it has worked its way into both side id the bracket?

 

[roscoe]

Doesn't the transducer and entire center section snap/hinge upward.
Grab the transducer and pull out away from the transom.

Scroll down to pages 3 and 4 on this pdf.

https://humminbird.johnsonoutdoors.com/sites/johnsonoutdoors-store/files/assets/misc/HU/H/HUM_productmanual_IG_XNT_PKU_532314/HUM_productmanual_IG_XNT_PKU_532314.pdf

 

[Alumarine]

As roscoe says it's hinged.
The hinge is at the top where it says Humminbird.
Pull or pry from the bottom.

 

[CWR782]

Roscoe you were right. Sorry for the delay in responding. Just got it out of storage. Thanks for the help.

 

[roscoe]

Great.
I had to remove one of those off of dad's boat a few years ago, had to refer to the install instructions to figure it out.