Converting 1950s to fuel pump

Outdoordawg

Recruit
Thread starter
Joined
Aug 28, 2015
Messages
5
I have 4 1950s evinrudes that I am thinking of converting to a fuel pump, the 5.5 hp I know needs either a vacuum line cap put in one of the check valve holes or fill in one of the channels behind the manifold, my 7.5, 15, and 18 I can drill and tap an 1/8" (1/8" pipe thread but what size hose barb?) hose barb into the port cover and put a vacuum cap on the old pulse nipple, in doing this so I still need to pull the check valves or is capping the old line off all I need to do?

Also to make this more complicated I already have an 18hp fuel pump port cover and fuel pump BUT I don't trust the near 50-60 year old diaphragm , what pump should I replace it with? And for the ones I have to drill and tap , what pump should I use with those(I've heard the Briggs pump is easy to use, anyone else using a Briggs pump?)

Thanks
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Yes, cap the pressure hose fitting if not using it. Leave the check valves in.

For the one with a proper bypass cover, if it were mine, I'd use a Sierra 18-7351 pump

Yes, I have used a Briggs pump. It worked for me, but sometimes I wonder why. They really weren't made for 2-stroke motors. Maybe they just don't know that. Lots of people use Mikuni pumps. Use hose nipple sizes to match whatever you are using.
 

Outdoordawg

Recruit
Thread starter
Joined
Aug 28, 2015
Messages
5
When I drill the port covers, do I drill the center part out or am I better off making a 1/4" thick piece of aluminum and tapping that ? Then just make my own gasket to adapt it? And what pump should I run with that style setup?
 
Last edited:

Crosbyman

Admiral
Joined
Nov 5, 2006
Messages
6,298
No Title

I have used the round B&S pump on my 5.5 and it works great .Modified the intake manifold check valve and used the old pressure nipple as a pulse nipple
​to the work the round pump. The triangular bracket was bolted on the rear cross member.
 

Attachments

  • photo240455.jpg
    photo240455.jpg
    96 KB · Views: 0

kodibass

Master Chief Petty Officer
Joined
Apr 10, 2010
Messages
865
I like the mikuni pumps far better quality than the BS pumps,, I make my own covers out of quarter inch aluminum, and my own gasket I have about 20 or so converted in this manner all run stellar ,,, kodi
 

Crosbyman

Admiral
Joined
Nov 5, 2006
Messages
6,298
The round B&S pump illustrated is a bit of a jack of all trade....

the dealer I got it from was nice enough to inform me that if the pump is sold for engine type X under one name it can go for $50 from engine type Y
​$35 and finally I purchased mine for $23 as a genuine B&S part #808656 and behind the pump is stamped MIKUNI made in Japan

I suspect the pumps are all the same..... just marketed under different names. :facepalm:
​
 
Top