Compression Check - "Pack-to-Armature"

akitchell

Recruit
Thread starter
Joined
Apr 28, 2016
Messages
4
I believe my water pump failed and caused my motor to overheat while on the lake. Before dumping money into replacing the water pump, I want to do a compression check. My manually tells me to "disconnect the power pack-to-armature plate connector to disable the ignition system". Is this the pull cord that is attached to my throttle control unit?

I have a 1984 70hp Evinrude.
 

GA_Boater

Honorary Moderator Emeritus
Joined
May 24, 2011
Messages
49,038
Welcome aboard.

What the manual is saying and not very clearly, is you can blow out the power pack by turning the motor over with with the key and no plugs connected to the wires.

I'm not up on this Evinrude, but the lanyard kill switch on the does disable the ignition, so it should be the same as "disconnect the power pack-to-armature plate connector to disable the ignition system" because it does the same thing because it's the same as turning the key off.

Wait for one of the Rude guys to agree or disagree with me before trying in case I'm not right.
 

akitchell

Recruit
Thread starter
Joined
Apr 28, 2016
Messages
4
Thanks! New to the boating world and I'm certainly a DIY person so places like this are a tremendous help.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Another reason for disabling the ignition system is to prevent starting a fire caused by sparking in the area of fuel vapors blowing out the spark plug holes. Never mind how I know.
 

akitchell

Recruit
Thread starter
Joined
Apr 28, 2016
Messages
4
Thanks for the advice. I was able to check the compression and had the following:

Cylinder 1: 110 psi
Cylinder 2: 100 psi
Cylinder 3: 110 psi

Does this seem reasonable? According to the manual, as long as it is a minimum of 100 psi and all cylinders are within 15 psi then it is ok. Given the fact that it did overheat, should I be concerned by any of these readings?
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Any time a motor overheats, the head gasket and exhaust gaskets should be replaced. As you do this, you will be able to inspect for further damage.
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Replace the water pump, re-torque the head and exhaust gaskets and give it a try.
 
Top