Pitcherofnectar
Cadet
Thread starter- Joined
- Sep 11, 2016
- Messages
- 8
Hello forum,
I picked up this "garage kept" 1955 Evinrude 25 this weekend. it was stored drained and with the plugs out about 30 years ago. Mice at some point took residence under the power head. the combo of open cylinders and mammal farts over decades made the Pistons stick pretty bad, though I was able to get them moving surprisingly easily with a bit of marvel oil. Everything turns really great now, never felt like I was powering through anything or like any damage occurred.
The is my first attempt at an outboard revival, and I did find the Top a Secret StickyThread with a post on "waking up a sleeping engine" and I've decided that is the path I'll follow. My question is, how much compression is "good" for this motor? The service manual gives a pretty qualitative description of good compression, but I'm a numbers guy and got a gauge from auto zone and plugged it in. when I pull the rip cord each cylinder gets up to about 95psi. Is there hope for me?
Also; I couldn't see a spark in the new spark plugs as I was holding them by the boots and turning the flywheel, but it def felt like I was getting electrocuted!
I'm in no rush here, I'm in school all winter and this will hopefully be my study break project I can do a hour or two on here and there. I can upload pics but not until I get to the library, my phone isn't doing it this AM for some reason.
Thanks!
I picked up this "garage kept" 1955 Evinrude 25 this weekend. it was stored drained and with the plugs out about 30 years ago. Mice at some point took residence under the power head. the combo of open cylinders and mammal farts over decades made the Pistons stick pretty bad, though I was able to get them moving surprisingly easily with a bit of marvel oil. Everything turns really great now, never felt like I was powering through anything or like any damage occurred.
The is my first attempt at an outboard revival, and I did find the Top a Secret StickyThread with a post on "waking up a sleeping engine" and I've decided that is the path I'll follow. My question is, how much compression is "good" for this motor? The service manual gives a pretty qualitative description of good compression, but I'm a numbers guy and got a gauge from auto zone and plugged it in. when I pull the rip cord each cylinder gets up to about 95psi. Is there hope for me?
Also; I couldn't see a spark in the new spark plugs as I was holding them by the boots and turning the flywheel, but it def felt like I was getting electrocuted!
I'm in no rush here, I'm in school all winter and this will hopefully be my study break project I can do a hour or two on here and there. I can upload pics but not until I get to the library, my phone isn't doing it this AM for some reason.
Thanks!