I recently bought a set of replacement gauges for a project boat from a new old stock/discontinued stock source. It doesn't currently have a fuel gauge, and all of the gauges i got came with no box/no instructions. No big deal except the fuel gauge doesn't have terminals, but rather a Duetch 6pin type connector, with four pins. From what i can tell, the connections should be ignition (power), fuels sender, ground and light.
I'm going to have to make the harness for it from scratch. From what I've found, these were used quite a bit on Triton boats at one point.
I can probably trial and error till i figure it out, but thought maybe someone here might know what the pin sequence should be and save me a bit of time.
Thanks in advance
I'm going to have to make the harness for it from scratch. From what I've found, these were used quite a bit on Triton boats at one point.
I can probably trial and error till i figure it out, but thought maybe someone here might know what the pin sequence should be and save me a bit of time.
Thanks in advance