Beede Fuel Gauge Wiring

Rainman57

Recruit
Thread starter
Joined
Feb 5, 2012
Messages
3
I recently bought a set of replacement gauges for a project boat from a new old stock/discontinued stock source. It doesn't currently have a fuel gauge, and all of the gauges i got came with no box/no instructions. No big deal except the fuel gauge doesn't have terminals, but rather a Duetch 6pin type connector, with four pins. From what i can tell, the connections should be ignition (power), fuels sender, ground and light.
I'm going to have to make the harness for it from scratch. From what I've found, these were used quite a bit on Triton boats at one point.

I can probably trial and error till i figure it out, but thought maybe someone here might know what the pin sequence should be and save me a bit of time.

Thanks in advance
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Beede Fuel Gauge Wiring

My suggestion would be to google the make and model of the gauge with the added words "connections" or something similar. Let your fingers do the walking. Someone here may have an answer for you but it wouldn't hurt to try Google or Yahoo search.
 

Don S

Honorary Moderator Emeritus
Joined
Aug 31, 2004
Messages
62,321
Re: Beede Fuel Gauge Wiring

Those sound like gauges used with a Can Buss system (digital). I know Volvo used them, and they were powered through an HCU (helm control unit) that was fed by the ECU (engine control unit). They are not compatible with standard gauge systems.
 

dmccaffrey

Seaman Apprentice
Joined
Oct 30, 2008
Messages
32
Re: Beede Fuel Gauge Wiring

While these do appear to be part of the InstuLink CANBus instrument set, they also seem to come in *after* the DA conversions take place and therefore, they might be able to be used as a regular gauge. After searching through Beede's web site (which is not very good), I found the following pin-outs for the Duetch 6-pin connector on the 2" gauges:

Pin 1: battery +
Pin 2: ground
Pin 3: sender
Pin 4: light +
Pin 5: not used
Pin 6: not used

Viewed from the back of the gauge, pin 1 is in the upper right, pin 3 is the lower right, pin 4 is lower left, pin 6 is upper left.

If you want to see for yourself, go to http://www.beede.com/xSales.php. Scroll down to bottom and you'll see 3 pictures of a sales brochure. The third page has the pin outs. They also have a customer support forum but I don't know how useful it is.
 
Top