Hello
First post here.
I have a 1982 glastron with built in tank. The gas gauge always reads below empty. I have crossed with a wire from ground to s connection on the gauge and it goes to full so the gauge is working. I diisconnected the s wire from the sending unit and touched the ground wire from the gas gauge to the sending unit and it also went to full. I have a ground post on the tank and have my ground wire from the gas gauge connected to that post. when I remove the s cable from the sending unit and touch one of the sending units mounting screws the gauge shows full. I assume I have proper grounding. I have not taken out the sending unit as of yet and want to make sure I dont have a wire issue first. My question is does every thing sound like the wires are hooked up properly? I suspect a stuck float. What do ya'll think?
First post here.
I have a 1982 glastron with built in tank. The gas gauge always reads below empty. I have crossed with a wire from ground to s connection on the gauge and it goes to full so the gauge is working. I diisconnected the s wire from the sending unit and touched the ground wire from the gas gauge to the sending unit and it also went to full. I have a ground post on the tank and have my ground wire from the gas gauge connected to that post. when I remove the s cable from the sending unit and touch one of the sending units mounting screws the gauge shows full. I assume I have proper grounding. I have not taken out the sending unit as of yet and want to make sure I dont have a wire issue first. My question is does every thing sound like the wires are hooked up properly? I suspect a stuck float. What do ya'll think?