I believe its an 88 .
Im putting a 115hp suzuki four stroke on it .
I only removed the centre section of foam because the sides still looked good . Boat was sandblasted from the blue down .I will paint that in the spring . I was afraid that the aluminum was damaged on the bottom but as it turns out its in very good shape . The gas tank is a 20 gallon in the centre of the floor .It was damaged and resembled swiss cheese .Small holes and lots of them . I repaired it with gaswell epoxy and it turned out really good . I had my doubts . I did however save enough while doing the repair to coat the outside as well as the inside . a little insurence.
I will attempt posting some photos over the next couple days . I have no quite fiquired it out yet .
I bought it allready torn apart . Wood floor was rotted completely . As for the foam . I used a spade shovel . Jam it into the foam like you would for dirt then pry back . Foam pops right out . Do this every 6 to 8 inches . Wasn't so bad to remove .
....I should tell you that there was a fuel leak in this boat . That could have aided the removal of the foam from the floor .
Last night I was installing the new 1 1/2" fuel fill line . As I removed the old one I noticed that it was jammed into the hull and Held in in between the stringers . These stringers had sharpe edges and the foam was soaked with fuel there as well .
I used more uhmw to cover the stringers and install the new fuel line . Pics to come .
