20PRIVATEER
Recruit
Thread starter- Joined
- May 28, 2011
- Messages
- 5
:facepalm:
I'd first like to say, Hi to all and I'm glad to be aboard.
I recently purchased a used 24v trolling motor. I picked up two new and matching 12v battiers and wired them in series with a jumper going from + on one and - on the other.
The first da that I used the motor it only lasted for a short time before it ran out of juice. So...I went home and charged the first batt. over nite. The next afternoon it had a full charge so I went to switch out...but when I hooked up the second batt. it already had a full charge. so...I hooked the batteries in series and checked them with a volt meter and they read 24v. so I assume my jumper wire is fine.
We went fishing this morning and the same happened again but with the opposite batt.
This time I had a volt meter with me and did a check. One batt. was stone dead and the other still read 13v.
so...I switched them around and keep fishing until a storm ran us to the hill.
What could be causing this?
Thanks for the help.
Joe
I'd first like to say, Hi to all and I'm glad to be aboard.
I recently purchased a used 24v trolling motor. I picked up two new and matching 12v battiers and wired them in series with a jumper going from + on one and - on the other.
The first da that I used the motor it only lasted for a short time before it ran out of juice. So...I went home and charged the first batt. over nite. The next afternoon it had a full charge so I went to switch out...but when I hooked up the second batt. it already had a full charge. so...I hooked the batteries in series and checked them with a volt meter and they read 24v. so I assume my jumper wire is fine.
We went fishing this morning and the same happened again but with the opposite batt.
This time I had a volt meter with me and did a check. One batt. was stone dead and the other still read 13v.
so...I switched them around and keep fishing until a storm ran us to the hill.
What could be causing this?
Thanks for the help.
Joe