Tomle91184
Cadet
Thread starter- Joined
- Jun 17, 2017
- Messages
- 6
94 evinrude 115hp E115TLERC compression test 100, 105, 100, 60 (cold) because the water tube and lower unit not in place. I pulled the head off that lower piston was pitted on top and the rings are gone, little to no scoring on the cylinder walls I took a tooth pick to the scoreing and didn't get bound up. The upper piston looked good with good rings, with almost identical scoring or scratching, with same results with tooth pick. I'm pulling the power head anyway to replace the water tube, so I'll pull the other head off to check the other 2 piston just in case. Should I just replace the rings on the lower piston or should I hone the cylinder and replace the piston and rings?
Last edited: