!993 Johnson 150 Oceanrunner stalls when running at speed

shadetr

Recruit
Thread starter
Joined
Jun 10, 2016
Messages
3
Hi folks, hope you can help.

In 2010 NAMARANTA wrote the following post

"Hey guys need some help. Got a 1992 johnson outboard 150hp, v6, 2 stroke with optical ignition. Engine stalls after driving for awhile (maybe a hour) or once engine is hot. No sputter or warning, just instantly kills. Verified no spark when fault occurs. Engine will usually restart after sitting for a few minutes and may run for another 30 or 5 minutes before it needs to cool again. Installed new power pack and optical pick up, new pick up wouldnt work???? so reinstalled old pick up with new power pack. Engine ran perfect for 2 full, hard days on the water before the exact same problem happened again. Put old power pack in and was able to get it back to the dock. Inspected all grounds, connections and engine harness. Nothing. Inspected stator, flywheel magnets and alternator rectifier. Advised by an "expert" to replace stator and alternator rectifier with CDI new parts. Took boat back out and same issue occured within 45 min. No miss fires or rough run, just instant cut out and usually will restart within 20 min of resting. Any suggestions?"

As near as I can determine my 1993 Johnson 150 is doing exactly what his engine was doing. Starts fine, idles smoothly, run it at normal cruising speeds or wot and it may shut down as if you switched of the ignition, will not restart right away, 5 to15 minutes later it will restart and run normally, sometimes it will run OK for hours but also maybe just a few minutes before it fails again.

NAMARANTA never posted a solution if he found one. Anybody out there got any clues before I start replacing a lot of expensive parts?
 

MaPaHa

Petty Officer 1st Class
Joined
Jul 6, 2012
Messages
239
I have two of these motors on two different boats (a '96 175 hp on a fish and ski boat and a '94 150 hp on a pontoon) and the 175 had the same problem 2 years ago. Running good and then shut off like you turned it off. You could get it restarted one way or the other usually and get back. Having the other motor made the troubleshooting easy so I robbed the entire ignition module, power packs and wires from the 150 and swapped it out and we've been using that boat every since with no problem. The 150 has been setting up for two years because I changed the pontoons and we are now putting it back in operation. I bought a OMC power pack and all three coils but not the wires. When I get my O ring problem solved on the fuel system I post back to let you know if that fixed it. My gut feeling is the ignition module was the only problem. From what I've read on this forum, buy the OEM part or possible the CDI part.
 

MaPaHa

Petty Officer 1st Class
Joined
Jul 6, 2012
Messages
239
The motor ran great this weekend without any trouble. I can't say if it was the ignition module or one of the coil packs but replacing them both did the trick. As I mentioned before, I think it was the power pack.
 

shadetr

Recruit
Thread starter
Joined
Jun 10, 2016
Messages
3
I bought and installed a new omc power pack last week. I started the engine and ran it for a while using the ear muffs. Engine ran normal. Took it to the lake and ran it for a little over an hour at varying speeds. Engine performed great. I think my problem is solved. I plan to take a trip to the Florida gulf coast for some inshore fishing next week. That should be a good test. I will post results after the trip.
 
Top