85 Johnson WOT Issue

Jmcjunkin3

Seaman Apprentice
Thread starter
Joined
Jul 15, 2017
Messages
49
Hey guys, so I had a topic previously open about my 1977 85 Johnson. I got everything tweaked out, and took it out on the water. The butterflies in the carb open fully, and the engine sounds like it's running very smoothly, but it's not hitting full rpm. Won't even get up on plane. Here is what I had on my other thread, figured opening a new thread on this new issue would be for the best...

Alright guys, better day today than my last run, but also not good. I started the boat up, let it fast idle for a bit, then took it off the trailer. Tied it up, parked the truck, and got back in....it took off, but only if I kind of hit it suddenly. I thought maybe It'd clear. Well...I got out of the no wake zone and went WOT. It sounds super smooth, no missfires whatsoever, but it just wont go upstairs AT ALL. It wouldn't even get up on plane. This boat used to top 45 easily....made sure the throttle plates were opening fully, check. Made sure the timing advance was all the way up, all good there. Decided to beach the boat and investigate further. Well....the battery was deader than hell. Fully charged and cranking well when I left the dock, suddenly dead...jumped it off and it ran perfectly fine, just wouldn't go upstairs again. Got it back to the dock, hooked my mulimeter to it, and got a lame 12.21 volts...mind you, this motor was putting out decent voltage just the other day...over the course of a minute or so, it rose just a tad to 12.24 or so, but never the 14+ I should be seeing...could a charging issue be causing a lack of RPM? It seems reasonable to think that if the coils/powerpack arent getting enough power, they won't perform as they should...any suggestions would be great! Here is a video I took of the situation.

https://drive.google.com/open?id=0B6...klfc3dOUWZ3bTg
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Nope ---12 volts is not used to make spark for the plugs on this motor.-----The stator has alternator coils to charge the battery and a seperate system with " charge coils " for the ignition system.-----The motor will run with a totally dead 12 volt battery hooked up !!
 

Jmcjunkin3

Seaman Apprentice
Thread starter
Joined
Jul 15, 2017
Messages
49
Gotcha...So best practice would be to test both circuits right? Testing at the power pack last time I got around 13 or 14v...
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
There is no voltage from the battery going to the powerpack !
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
You say the timing is advancing, but is timing is set at correct max advance?

You said the boat used to do 45, must be a very small boat to get a crank rated 85 to do 45. Anyway, was something changed/replaced and the performance changed? Or it did work fine one moment and the next it didn't?
 

derek4325

Petty Officer 2nd Class
Joined
Mar 7, 2015
Messages
167
Check out your carbs and the fuel line going to them. Also check your gas for water. It sounds as if your high speed jet isn't working properly. Take them apart carefully and clean them out good. Better practice would say to put new carb kits in as well. And since you have it all apart replace the fuel line as well. I'm going to take a shot in the dark and say it's not an ignition problem because it's running smoothly. I wouldn't mess with the timing especially if it ran good before. However check your timing advance stopper to make sure it didn't get loose. If none of that works it could be your fuel pump too. Run it at WOT and have someone squeeze the primer bulb. If it takes off then you found your issue. My educated guess would be that it's starving for fuel. Make sure you have absolutely no air leaks in any fuel lines or connectors as well. Best of luck and let us know what you find!
 

derek4325

Petty Officer 2nd Class
Joined
Mar 7, 2015
Messages
167
And as far as charging goes you're probably not seeing the voltage because you can't get your RPMs up. A lot of those older OMCs had pretty low output charging systems on them and you have to be moving at a pretty good clip to get and juice out of them, however I'm not 100% positive what yours puts out. You may have an excessive draw from an accessory in your boat that you don't realize. Anyways get your WOT issue fixed and then you can examine your charger issue. As racerone already said the battery is not needed to keep the engine running.
 

Jmcjunkin3

Seaman Apprentice
Thread starter
Joined
Jul 15, 2017
Messages
49
Gotcha...so just for the record this is what I have done and checked so far:

2 new coils
all new fuel lines
carb kits/ soak/ and air blown through, as well as tag wire ran through all passages
new fuel pump
cleaned and lubed timing advance assembly under flywheel
fresh gas several times
checked compression, 115 on all cyls
good blue spark on all cyls
wot timing set at 24 degrees

this is worlds better than how it was running when I pulled it from storage, it's almost there, just needs some tweaking at WOT.
 

Jmcjunkin3

Seaman Apprentice
Thread starter
Joined
Jul 15, 2017
Messages
49
jimmbo, it ran good besides a random missfire at WOT when it was put away 4+ years ago. pulled it out this season and went through everything that should be gone through when pulling an old boat from storage.
 

fireman57

Captain
Joined
Aug 24, 2004
Messages
3,811
I cleaned my carbs four times before I finally got whatever was in a high speed jet. Turns out one of my fuel lines from the tank was rotten on the inside and small chunks were getting in there.
 

Jmcjunkin3

Seaman Apprentice
Thread starter
Joined
Jul 15, 2017
Messages
49
So...stupid question. Would a 4 cyl johnson motor be able to run as well as it did in the video if only 2 cylinders were firing? I just checked spark again and it's perfect on the right bank, literally no spark on the left now...sounds like my powerpack has finally taken a crap. I disconnected both plugs on the left and it still runs exactly the same. Problem solved? Just odd to me because it seems like it's running exceptionally well for running on 2 cylinders lol. Empties my cut down 55 gallon drum everytime I hammer it.
 

Jmcjunkin3

Seaman Apprentice
Thread starter
Joined
Jul 15, 2017
Messages
49
Further testing has confirmed it. Used a test light, only had signal coming from the 1&3 spots on the powerpack, nothing from 2&4. Sucks that it's a somewhat expensive fix, but boy am I glad to find a smoking gun like that!
 

derek4325

Petty Officer 2nd Class
Joined
Mar 7, 2015
Messages
167
Further testing has confirmed it. Used a test light, only had signal coming from the 1&3 spots on the powerpack, nothing from 2&4. Sucks that it's a somewhat expensive fix, but boy am I glad to find a smoking gun like that!

Hmm.. I must say I'm surprised usually you would know If you wernt firing on 2 cylinders. You would think it wouldn't ran nearly as smooth as you earlier described. Just make sure your power pack is what's bad and not your stator. Check all your signal wiring too, sometimes they rub under the flywheel and I don't need to tell you what happens next. A new stator will probably run you $3- 400 while a power pack is about $100. Neither of them cheap fixes but make sure you know which is bad. A service manual will tell you exactly what needs to be done. But check the easy stuff like the wire conditions first before you start dumping money into it. Best of luck
 

Jmcjunkin3

Seaman Apprentice
Thread starter
Joined
Jul 15, 2017
Messages
49
Yeah, I was just reading the CDI troubleshooting guide that is listed on the power pack page...I'd like to run this test here. Which wires are the timer base wires, though? I'm much more of a visual learner...are these the "sensor wires" on the pack? or are these somewhere else? thanks in advance!

jfq4D2B33h5vAAAAAASUVORK5CYIIA
 

Jmcjunkin3

Seaman Apprentice
Thread starter
Joined
Jul 15, 2017
Messages
49
No Title

didn't post the first time...sorry
 

Attachments

  • photo273671.PNG
    photo273671.PNG
    23.7 KB · Views: 0

Jmcjunkin3

Seaman Apprentice
Thread starter
Joined
Jul 15, 2017
Messages
49
Glad I did some more tests. Timer base trigger tested good on top (1&3), bottom tested bad (2&4) aka the bank i have no spark on. Going to make sure nothing is grounding out underneath, then go ahead and order a new timer base trigger. Thanks again guys.
 

Jmcjunkin3

Seaman Apprentice
Thread starter
Joined
Jul 15, 2017
Messages
49
Yup I tried...unfortunately I tested from terminal to terminal of the pickup to eliminate wiring as an issue but the pickup itself was bad. On the bright side, I tested my regulator while I was out and found that it was bad as well. So there's my charging issue right there.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
You're really getting a course/class on outboard 101
 
Top