80 HP Mercury trim

[Kissdude]

I was wondering where I can get the hydraulic parts for my trim motor. Was on the lake today and motor stayed down and would not trim up. I hear a click and that’s all but trims down fine. Any information would be appreciated thanks

 

[Mc Tool]

Might just be a relay . If your lucky you may be able to swap over the up relay for the down and see if the fault follows the relay . You could also use a volt meter to see if both relays are working.
There is only one trim motor that spins one way for up and tother way for down ...ergo , if the motor goes down it must be ok and the fault is most likely an up relay . The relays decide the polarity of the current flow supplied to the trim motor to give you up or down .

 

[Kissdude]

Ergo is the name of my trim? Ya I'm wondering where to find these relays, I know they're older pumps.

 

[racerone]

???----Year / serial # of this motor must be posted!

 

[Mc Tool]

no , ergo means " there for " ( its latin ) . I dont know where the relays are situated , but here are some
Basically little square boxes that plug in , most probly near the electrical connection bits on the side of your motor cylinder block .

 

[Chris1956]

Do you have the PTT with the trim pump and reservoir in the boat? If so, you can have one or two solenoids. The UP circuit will definitely have a solenoid, but the DOWN circuit may or may not have one.

I never had a solenoid go bad on that type of system, so first check the connections from the battery to the PTT pump solenoid. Then check to make sure the solenoid is getting +12VDC when the trim button is pushed. Do you still have the 3 button panel?

 

[Kissdude]

I believe it’s a 1979 80 HP Mercury 4832469 and the pump is inside boat. It was working on the lake but then stopped, had to lift from inside.. what a pain in the back lol. Think I have two solenoids and I control from the throttle up front. I hear a click for up and it goes down ok.

 

[jimmbo]

Might be a bad Solenoid, bad connection/Wire, as the Pump does run to lower the Motor

 

[Kissdude]

Any idea where to find a diagram and does the pimp have to come out to get solenoid out?

 

[redneck joe]

are the trim cylinders outside the motor or inside in the center area?

 

[Kissdude]

They are outside the motor

 

[racerone]

I believe those use a solenoid for UP and run direct through the switch for down.

 

[Kissdude]

are they easy to get out?

 

[redneck joe]

Pretty sure not the hydraulics. Juat moved so not aure where its at but I'll tey to find my service manual.

 

[Mc Tool]

Pretty sure not the hydraulics. Juat moved so not aure where its at but I'll tey to find my service manual.

Yrsh thr s snd the a, snd thr e snd thr a ser to cloar sftre s frw.

 

[redneck joe]

typing while pooping.

 

[Mc Tool]

typing while pooping.

Aaaw ,didnt need to know that

 

[redneck joe]

Aaaw ,didnt need to know that

yet here we are...

 

[redneck joe]

They are outside the motor

i did find my manual, it does not list the 80 hp however the trim system should be the same.

Below are some pics, need to determine what you have

 

[redneck joe]