61 evinrude 75hp 50525 tack hook up?

utah lakes

Cadet
Thread starter
Joined
May 31, 2016
Messages
8
I have two wires coming through the wire harness into the engine that are not attached to anything. Are those the leads that have to be attached somewhere to wire the Tach? The Tack is an old airguide P-5079 or 653 if that matters. the harness has 4GA red and black, brown, white, and 2 black, those are all attached. just the two others are unattached (white and Blue) Also as I am rebuilding the Harness any Ideas on wire shroud to clean and protect, Hate to just tape the hell out of it...
I don't have the the sending unit or regulator for the Tack and from looking at old air guide tack on ebay I have noticed some have it and others do not. Will that be required?
When I install the tack wires at the dash will that get wired through the ignition switch or perhaps direct using white and blue all the way to the motor direct to tach? Any help would be greatly appreciated.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
50525 has magneto ignition, and requires a suitable tach designed for such. Your old Airguide just might fill the bill, but I'm not smart enough to know. But 653 does sound familiar. The tach gets its signal from the magneto, and the signal is available at the ignition switch. It would be at the two "M" terminals. One comes from the magneto points and the other comes from ground. Now all you need is the instructions for a 653.

BTW, those two wires you asked about are for an accessory DC generator kit.
 
Top