'61 5.5hp Johnny impeller kit replacement

DoubleDan

Cadet
Thread starter
Joined
Apr 23, 2014
Messages
14
When attempting to take the lower unit off the shift linkage is holding me up. Is there a set screw somewhere. This is not like my '64 evinrude 28hp where there is a shift rod connector. Does anyone have a manual available?
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
You need to pull the powerhead off on that model to replace the waterpump. It has a 1 piece shift shaft that connects under the powrhead.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Nah, easy job. Good to look at a parts diagram, though. 6(?) screws from underneath holding the powerhead in place. Will need to remove the throttle tower -- look for a tiny spring down at the base (easily lost). The top of the driveshaft has a spring and seal assembly, and should pay attention to the assembly order. The shift shaft under the powerhead is threaded, held in place by a couple of nuts and a star washer, as I recall. When disconnected, will slide out with the lower unit.
 
Top