59 evinrude 35 hp

lilbuilder

Cadet
Thread starter
Joined
Mar 16, 2015
Messages
11
i have a 59 35 hp evinrude 35516, I've been working on it for awhile now but finally have it in a bucket of water and ready to fine tune it. The only problem is I had running once, very rough. I've haven't been able to start it since, I've done the carb adjustments where the top needle (low speed I believe) is 1-1/2 turns out and the bottom needle (high speed I believe) is 3/4 turn out. It does not run with these settings at all anymore, all it does is pop real bad and splash a bunch of water out. Please help me this motor has been driving me crazy. Any suggestions?
 

lilbuilder

Cadet
Thread starter
Joined
Mar 16, 2015
Messages
11
well if i adjust the throttle it will run, but if i put the throttle position to start it instantly kills it.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Do you have spark on both leads that jumps a gap of 1/4" or more, yes or no ?
 

oldrem

Commander
Joined
Nov 7, 2013
Messages
2,002
He means using a spark tester connected to the coil to see how good the spark is. One where you can adjust the test gap.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
ALL, as in ALL 1959 Evinrude twins have bad coils unless they have already been replaced. Have they? You are wasting your time until they are. And yes, that will cause loud backfiring and hard starting, among other ills.
 

lilbuilder

Cadet
Thread starter
Joined
Mar 16, 2015
Messages
11
Replaced coils, used a spark tester but not with an adjustable gap like he is saying, the spark tester and solid blue going through it.
 
Top