lilbuilder
Cadet
Thread starter- Joined
- Mar 16, 2015
- Messages
- 11
i have a 59 35 hp evinrude 35516, I've been working on it for awhile now but finally have it in a bucket of water and ready to fine tune it. The only problem is I had running once, very rough. I've haven't been able to start it since, I've done the carb adjustments where the top needle (low speed I believe) is 1-1/2 turns out and the bottom needle (high speed I believe) is 3/4 turn out. It does not run with these settings at all anymore, all it does is pop real bad and splash a bunch of water out. Please help me this motor has been driving me crazy. Any suggestions?