peacemaker48
Cadet
Thread starter- Joined
- Jan 8, 2016
- Messages
- 22
I've just finished a second carb rebuild along with points and condenser, new gas lines and inline filter . The tank test was inconclusive. Lake tested it on Fri. and the results were mixed. The motor started on first pull and ran OK on low speed idle after a minor adjustment ( it had on intermittent chunk or cough ) . After passing the no wake sign I slowly opened up the throttle and the motor begin a shutter or miss. The feeling I got was only running on one cylinder. This only lasted a few seconds (2 to 3 ) and at that point it picked up the gas and began to run great . I did some fine tuning on the high speed control and clocked my speed at 21 mph ( as good as it's ever done ). This problem seemed to stay with me thru the running however it did seem to improve somewhat. The lull between low power and full became less but not a smooth transition. Also I'm using the original 6 gal cruse-a-day gas tank ( very good pressure ) and have to kill it with the choke. Thanks for any advice.