Re: 24V System Troubles
I'm going to need to sneak up on this one so I'll keep asking questions and fill in the blanks as we go. We know you currently have a 12/24 motor because of the three wires from it to the plug. Next question: Do you plan to use the 12 volt function? If not, you don't need the switch. So here is the breakdown for the three motor wires:
Black = ground
Red = 24 volts (measured to black)
Orange = 12 volts (measured to black)
The wires from the batteries are paired as follows:
Black and red come from one battery
Black and orange come from the second batteryl
You need to determine which black wire is from the negative post on which battery. You need a test light, voltmeter, or ohmmeter to determine this if you can't determine it visually. Measure from the red lead to one of the black leads. If you get a reading, those two wires are paired. If you get no reading, measure from the red wire to the other black wire to verify. No need to measure the orange and other black as you've proven what the pairs are. Tag those wires BAT 1 NEG, BAT 1 POS, BAT 2 NEG and BAT 2 POS. It doesn't matter which battery you identify as BAT 1 and BAT 2.
Now then, you said it looks like they tried to bypass the switch. By that do you mean there are other wires that look added or messed with, or are just referring to these four?
I now need to know if the wires from the receptacle on the boat are connected to the switch or are they just hanging free as well.
Problem: I don't see how you can get 12v and 24 from the same switch setting so please look at the switch label carefully and confirm what you see.